New Genius K-touch read & write a ECU on the table

New Genius K-touch ECU Hand-Held Chip Tuning Tool is update of Kess v2 Master. New Genius K-touch support read and wrtie and remap ECUs. New Genius K-touch China Clone User manual, how to use New Genius K-Touch China Clone read & write a ECU on the table.

New Genius K-Touch China Clone New Genius Flash & Point K-touch ECU Hand-Held Chip Tuning Tool

14520727988 New Genius K touch to Flash&Remap a ECU User Manual

New Genius K-touch ecu chip tuning tool manual– How to use New Genius K-touch to read&write/flash/remap a ECU on the table.

 

What you should have for New Genius K-touch?

John Deere L21-L33 cable

New Genius K touch read write a ECU on the table 1 New Genius K touch to Flash&Remap a ECU User Manual

 

New Genius Flash Point

New Genius K touch read write a ECU on the table 2 New Genius K touch to Flash&Remap a ECU User Manual

The picture above display New genius k-touch original, customer can try to use the New Genius Ktouch Map China Clone for it.

How to New Genius Ktouch flash a ECU on the table

 

Step 1

After removing the ECU from the tractor, wait for 2-3 minutes before you start the operation

Step 2

IMPORTANT: ignition must be off

New Genius K touch read write a ECU on the table 3 New Genius K touch to Flash&Remap a ECU User Manual

Step 3

Connect the New Genius with F32GN032 diagnostic cable

Step 4

Connect the L21-L33 cable to the ECU (ignition must be off)

Step 5

Connect the power cable from the L21-L33 with a power supply (+12V)

New Genius K touch read write a ECU on the table 4 New Genius K touch to Flash&Remap a ECU User Manual

Step 6

Select the correct vehicle and protocol FLASH_363

 

IMPORTANT: select TOOL to read at first the injector codes. For more info about this, take it from the Flashpoint Application list.

New Genius K touch read write a ECU on the table 5 New Genius K touch to Flash&Remap a ECU User Manual

Step 7

After reading the injector codes successfully, start to read the ECU

New Genius K touch read write a ECU on the table 6 New Genius K touch to Flash&Remap a ECU User Manual

IMPORTANT INFORMATION ABOUT THE PROCEDURE:

If the New Genius writes ECU, switch off the ignition, switch it off and wait until the Ampere cool down ca. 0.35A, before you click on OK on the New Genius! (cool down time ca. 10 sec)

 

Ignition OFF ca. 0.34-0.35 Ampere

Ignition ON ca. 1.10-1.20 Ampere

 

Reading ca. 50 sec.

Writing ca. 1min 50sec.

New Genius K touch read write a ECU on the table 7 New Genius K touch to Flash&Remap a ECU User Manual

Eobdtool.com IMPORTANT NOTE:

Usually, New Genius K-touch China clone (also named Ktouch) can work as the original.

 

For further questions about New Genius Ktouch Flash Point ECU chiptuning Tool.

 

Focus On OBD Tool Since 2008

Follow Us:www.facebook.com/eobdtool

Skype:eobdtool02

WhatsApp:(+86)13728823411

Email:sales01@eobdtool.com

Website:www.eobdtool.com

 

Leave a Reply

Your email address will not be published. Required fields are marked *